Page 1 of 1
Merlin Cap from Excalibur
Posted: Thu Aug 19, 2010 4:35 pm
by Pitbull Armory
Hi there, This was a recent job that was reffered to me by Hal at Therion Arms. The guy sent me a plaster cast of his head, I was going to raise it from one piece but I chickened out and raised both halfs, then welded the center. Thank you Hal. Check out Therionarms.com if you get time for some great deals on swords and armor.
Take care
Pitbull
Posted: Thu Aug 19, 2010 5:06 pm
by Halberds
That is cool.
I think the only way to make one fit is with a plaster head, or hammer it over a real hard head.
Well done.
I bet you will have a happy sorcerer on your hands.
Thanks for the pics.
Ron
Posted: Fri Aug 20, 2010 11:43 pm
by Therion
Beautiful work, Pitbull. I'm glad the referral worked out!
Posted: Sat Aug 21, 2010 5:44 pm
by Ingelri
Great Job, Pitbull. I have always liked that particular piece from Excalibur.
Ingelri