Harbor freight shear question

Maze · Post by **Maze** » Fri Apr 30, 2004 3:52 pm

i am looking at the throatless shear from central forge on the harbor freight website
and i looked for these awnsers but i could not find them
here are the questions:

what is its cutting capacity can it cut 16ga mild steel? and could i even push it as far as 14 ga mild steel?

and ive heard its been getting better this past while is this true??

and would you say its worth the money

sorry for the ramballing but im just doing some research before i make an order....

thanks alot

~Steve

Guy Dawkins · Post by **Guy Dawkins** » Fri Apr 30, 2004 4:12 pm

http://forums.armourarchive.org/phpBB2/ ... hp?t=29280

Check out this thread from a few days ago.

Maze · Post by **Maze** » Fri Apr 30, 2004 11:17 pm

oh thanks ...dident see that one :oops:

heh sorry for taking up space heeh

~Steve

Lord Ogier · Post by **Lord Ogier** » Sat May 01, 2004 12:31 am

Hey JT,
Can you make the Harbor Freight shear thread a sticky one? This is a recurring question.