The Armour Archive

My production queue has grown rather short and I'm looking to lengthen it somewhat by getting some bulk orders for the following items in 3/16"ID stainless steel. I also will allow mixing and matching of items (normally I require multiple of each desired item). The following are available for bulk orders and are listed with bulk prices and total weight:

Short Aventail (32" neck, 60" outside edge, 7.2" wide) - $95, 1.5lb.
Long Aventail (Short aventail with a 7.2" high tube at the neck) - $150, 2.3lb.

Small Fauld (48" around, 21.5" high, split 7.5" from bottom) - $145, 3.6lb.
Large Fauld (Same as small fauld but 60" around at waist) - $175, 4.5lb.

Sleeves (10" long and fits up to am 18" bicep) - $50, 1lb.
Voiders (Sleeves that also cover the shoulder and below armpit) - $100, 1.4lb.

Shipping is not included but will be around $15 via USPS flat rate depending on the size of the order. All items in an order must be payed in a single payment and be shipped to a single address. I may require payment upfront but the full amount is fully refundable before shipment (it may take up to two weeks for refund to go through).

Further Discounts:

- Order 10 of any item and get 10% further off of that item.
- Get $10 off each fauld when matched with a pair of voiders.
- If you order $2000 or more I may bump the order to wholesale pricing and pay up to $50 shipping depending on the items being ordered.


Here is a comparison picture of the ring sizes I use (3/16", 5/32", and 3/32"):



The surface finish will be burnished, which looks like aged mild steel:



Please mention this post when ordering.
Cheers,
-Ben

3/16 should say 3/8

The rings are ~3/16" (5.6mm) ID. They are slightly smaller than the 6mm stuff from india but are less expensive and far lighter.

-Ben

Whoops the tape is narrow and threw me off was reading it wrong.

How much for a single tall aventail?

Edward

What quantity is bulk?
Or did I miss that in the post?

Adam

Sorry, $500 and at least 5 items is the minimum for bulk orders for now (it'll go up after this sale ends).

A single long aventail would be $165.

-Ben

EDIT: Long aventail price was supposed to be $175, not $165. However, I'll let it stay that price for the rest of this sale.

This 'sale' ends August 1st. The prices will still be the same (or similar) but the minumum order will be at least doubled to get the same price.

-Ben

First to order will get wholesale pricing.

Also, there is enough 5/32" titanium to make one shirt (around 12 square feet), 3 pairs of voiders, or 4 short aventails. I will include the TI aventails and voiders in this sale.

-Ben

Update: I have ordered enough material for several bulk orders and will not require any upfront payment for the next few orders.

-Ben