The Armour Archive

Stonekeep: New Beverley B3 Shear

http://ep.yimg.com/ca/I/spiers-saddlery_2157_7590914

About three years ago, I unbolted my B2 and bolted this one down temporarily, cut out about a dozen helmtops from 12 gauge steel, then unbolted it and put it on a shelf where it has sat in a climate controlled facility... Im calling that New.. No rust whatsoever of course. Blades are perfect of course.

I just did a rundown of some new prices online:

Tinman was 1083
Irvan Smith was 1081
Batavia machinery was 1048
Old rusty model on a classifieds missing a handle was 750


I will consider any offer over 780 in cash, and in person...

I am halfway between Dallas and Houston on Interstate 45

Bump.. hopin for some interest. Hate to sell it this cheap to some random person off craigslist

What would shipping run to 60101?

I havent looked into shipping yet...

Only thing i have available locally is the post office. You are looking at about a 70 lbs package when boxed I imagine.

Id also have to try to find a much better box than anything i have available. cardboard may not can even handle something like this.
Im thinking they come in crated normally.

Forwarding this to my boss.

I commonly end up building a wooden box that just slides in the Flat Rate USPS boxes when shipping heavy items; saves a lot of grief... I doubt a B3 would fit a flat rate box though.

Hi, Shipping for a Shear like that would be 60-75 dollars in usa if I recall. Wish you lived closer to me Id like B3 around the shop.

Have a good weekend

Andy @ Pitbull Armory