summer

accdntprone · Post by **accdntprone** » Tue May 22, 2001 7:50 am

Im online a lot less right now because Im at home a lot less. Im working full time over the summer instead of going to school. That Im not around much right now does NOT mean that Im not going to get the rest of them late orders out though. Current status,

Baculas, one scutem done, one welded rod shield basket (thanks for the pattern otto) done

Steve, some blanks formed but uncut, I know you want kite shields but how tall and wide?

Daveid Blackmane, Are you the one getting this heater shield that I made and dont remember why? Or are you suppose to be getting a kite shield?

Galileo · Post by **Galileo** » Tue May 22, 2001 1:41 pm

A friendly *bump*

(as opposed to a hostile one...

)

Aaron · Post by **Aaron** » Tue May 22, 2001 7:14 pm

bump (also friendly).

Baculus · Post by **Baculus** » Thu May 24, 2001 6:34 pm

Cool, Accidentprone. Sounds good to me! let me know when it's been shipped...

Baculus

Steve S. · Post by **Steve S.** » Fri Jun 01, 2001 1:23 pm

From my 1/16/01 email:

<i>John:

I've attached a picture that shows what I'm looking for. I want a shield that is not quite as tall as the black and white shield, but a little taller than the white-with-red-cross shields. I'm figuring about 40" tall and about 20" wide, but let your eye dictate the exact proportion to make a decent kite shield. I'd like it slightly curved. Let's go with the 1/4" thick - I'm going to use it for SCA combat as well. I'd like to buy 2 blanks.

Do you have an address where I can send a check? Thanks.

Steve</i>

accdntprone · Post by **accdntprone** » Fri Jun 01, 2001 1:48 pm

Thanks for the reply, will cut the things out and get them ready to ship.

Aaron · Post by **Aaron** » Fri Jun 01, 2001 3:18 pm

Accdntprone,

Any luck with the helm halves?

-Aaron