The Armour Archive

I'm looking to sell this coat of plates kit. It's my pattern and my handiwork, made from .08" 5052-H32 aluminum. The kit is designed for a side-opening COP, because I prefer to wear armor that I don't need help getting into and out of. Protection for the spine is included. All the holes are punched and the edges were dressed with a grinder. You may wish to further clean up the edges or add additional holes, depending on how you intend to strap it.

This kit should fit someone who wears a size small or medium men's t-shirt.

Asking $75.00 plus shipping. I can accept PayPal or a check.


Both sides.


Front.


Back.

Thanks for shopping,

Adam

Bump.

Can you find out what shipping to Canada postal code K0C 2Co would be? I may buy this and turn it into loaner gear if the shipping isn't to expensive.

kaolin wrote:Can you find out what shipping to Canada postal code K0C 2Co would be? I may buy this and turn it into loaner gear if the shipping isn't to expensive.

Since the largest plates are only 12" long, I might be able to fit it in a large flat rate envelope, which would cost $12.95 plus insurance (which is minimal) - this is for USPS Priority Mail. I can confirm tomorrow afternoon if it'll fit or not.

Adam

It looks to an untutored fellah like me to be a very faithful reproduction of a Wisby type one, and seventy five bucks isn't bad. In fact, it's a great price.

f

I'm interested, if you think the plates would work for a lady's coat...and depending on cost of shipping to Alabama, zip code 35603. Thank you!

I'll DEFINITELY call second dibs on that. Gimme gimme gimme.

Adamo, assuming this one is sold would you be interested in making me one? Feel free to PM me.

Posts responded to via PM.

I have enough aluminum to make a few more of these if there is interest.

Adam

OK, shipping turned out higher than expected so I am releasing my interest. dibs. Sorry for the delay folks.

PM'd you Adamo.