Page 1 of 1
WTB: Rus nasal or sheet brass
Posted: Thu May 31, 2012 3:26 pm
by Sevastian
I am putting a pseudo-Rus helm together and am looking for a nasal in brass or some 14 gauge sheet brass so I can cut one out myself. Any info would be much appreciated.
I have just been told what I'm looking for is an occular. I will post pics if I can find any.
Re: WTB: Rus nasal or sheet brass
Posted: Thu May 31, 2012 8:00 pm
by Eirik
Re: WTB: Rus nasal or sheet brass
Posted: Thu May 31, 2012 10:32 pm
by Sevastian
I've seen that site before and would love to use those fittings on a helm someday. Since the helm will be used by a noob(me), what I'm looking for would be far less beautiful.
Re: WTB: Rus nasal or sheet brass
Posted: Fri Jun 01, 2012 8:09 pm
by Eirik
Ok then
http://www.amazon.com/s/?ie=UTF8&keywor ... jl8bnrlr_b
**EDIT**
I was curious myself. Turns out, you can get a 3" x 12" piece of .093" thick for about 20 bucks or .062" for 16.68.
I'd say that should be enough to make a nasal....
!
http://www.amazon.com/dp/B000FN14D4/ref=biss_dp_t_asn
http://www.amazon.com/dp/B000FN1GT6/ref=biss_dp_t_asn