The Armour Archive

Ok so I am getting into making rapiers and two handed swords for SCA fencing. This is my selection of pommels that I will be offering. The first batch will be finished in 2 weeks and will be available for sale. The sizes range from the 2.25" two sword pommel down to the mushroom pommel I usually offer. They will be satin finished and 6mm drilled and tapped but I can make them slotted to fit flat tang for an additional cost. I would like 25 dollars each for them and I should have a few of each ready to go. Other pics of the pommels mounted on swords can be found on my fliker page but the pattern board can be seen here
http://www.flickr.com/photos/40421015@N02/9467582828/
PM me if you are interested
Thanks again!