The Armour Archive

This was one of two helms I bought at Pennsic years ago to convert into a helm for play with rebates blades... I decided to convert the other helm and this one ended up spending most of its time so far as a bookend. This one came from Icefalcon, a bottom shelf apprentice project if I recall correctly. I paid $150 for it then and it would certainly cost more today, but I'm asking $140 (+ shipping) now.

I haven't measured it with a gauge, but I think the top is 14 and the cheeks, back, and nasal look to be 18 gauge. Its stainless.


http://mailmaker.tripod.com/forsale/norb.jpg
http://mailmaker.tripod.com/forsale/norc.jpg
http://mailmaker.tripod.com/forsale/nord.jpg
http://mailmaker.tripod.com/forsale/nore.jpg

Be a good start for a youth helm.

Says connection refused when I hit the first two links.

Anyone else not able to see some of the pics? I'm not sure why it would give that message, I haven't seen it before.

What size head does it fit? And how much for you to finish turning it into a C&T helm?

Thank you
Catain

I am interested in it depending on its size.

Sorry it took so long updating this - I went to measure the helm and found that when cleaning my shop a while back I must have put this helm "someplace safe". Anyways, I've found where I had stashed it .

The inner circumference is 26 inches without any padding.

I don't think I could mod it much in my shop, at least not until I get a welding torch and gas.

need to measure my head first but I am interested

Hmm i think i might be able to use that...Hwo much would shipping be and how do you prefer to be paid?

Sorry for the delay, pm me your zip code and I can figure out shipping. I can take a check, money order, or PayPal for payment.