Printing Craig's Brig Pattern

Wolf · Post by **Wolf** » Sat Apr 24, 2004 7:49 am

http://www.eskimo.com/~cwn/brig_craig1.html

ok printed out 1 of the patterns. the 1 inch square comes out more like 7/8 x 7/8 squares. tried to put all 0's in the margin, but it kept putting a small margin in place. HELP? also tried to skew/strech but couldnt find all 4 numbers needed (2 for stretch and 2 for skew) that would make it come out right

white mountain armoury · Sat Apr 24, 2004 8:37 am

poke around his site, it explains how to print his patterns to correct scale

Wolf · Post by **Wolf** » Sat Apr 24, 2004 8:50 am

DUH thanks adam. i got it down to 1/16 of an inch on the square. figured it was close enough. by the time i trace and cut i'll have made up the 1/16

mattmaus · Post by **mattmaus** » Sat Apr 24, 2004 1:11 pm

Depending on how big or small you are you may need to scale them anyway.

For the record, it seems that if you cut on the INSIDE of his lines that the paterns work better. I suspect this is because he traced his originals onto the graph paper with a marker. and so the INSIDE of the fat line is where the original actualy was.