Page 1 of 1
A question for Halberds, maker's marks
Posted: Mon Jun 30, 2003 10:17 am
by Zweihammer
Halberds, I copied down the information you posted on a maker's mark you purchased. My question is how well has it held up, was it a good investment? It seemed crisp in your first picture but I have seen some numberstamps loose thier edge quickly and become blurry and others that have chipped and flaked. Thanks for the information.
Cheers, Erick D.
Posted: Mon Jun 30, 2003 10:38 am
by Halberds
https://www.argontool.com/ecatalog/frames/default.aspThe stamp is of the highest quality. Mine has some very sharp detail and crisp edges.
I have played with it a lot and there are no signs of wear.
Best of luck;
Halberds
Posted: Mon Jun 30, 2003 10:40 am
by Halberds
Posted: Mon Jun 30, 2003 11:36 am
by Zweihammer
Thanks Halberds, I think I will order mine now.
Cheers, Erick D.
Posted: Mon Jun 30, 2003 12:02 pm
by Halberds
This is what mine looks like.
[img]http://www.cox-internet.com/halberds/stamp1.jpg[/img]
They did a fine job on it.
Posted: Mon Jun 30, 2003 12:16 pm
by Zweihammer
Halberds, about how large is that?
Cheers, Erick D.
Posted: Mon Jun 30, 2003 12:53 pm
by Halberds
The longest length; from tip of the halberd to the end of the shaft is .59"
The design will fit in a 5/8" circle.
I have heard that 1/2" is a good size.
It will work on curved pieces better.
Happy stamping;
Halberds