Page 1 of 1
Greatsword Thrusting tips
Posted: Tue Feb 08, 2011 10:40 pm
by chris19d
Did the new "only has to be as wide was the weapon" rule go into effect or do tips still have to be 2" in diameter?
Posted: Tue Feb 08, 2011 10:50 pm
by Larmer
Width of the rattan,
"(b) When thrusting tips are used on rattan weapons with length less than or equal to 7.5',
they shall be at least the same diameter as the shaft of the weapon they are mounted on and have 1.5 inches (38.1 mm) of resilient material in front of the rigid tip of the weapon, thereby providing progressively resistant give. (Note: Pressing with the thumb into the center of the thrusting tip is not an adequate test. The give must be across the entire face of the tip.)"
You may want to go here and read all the changes that were made in March 2009.
http://www.sca.org/officers/marshal/ann.html
Posted: Tue Feb 08, 2011 10:55 pm
by chris19d
thanks
Posted: Wed Feb 09, 2011 8:35 am
by Baron Eirik
Some kingdoms may not have adopted this standard, please also check with your Kingdom rules.
Posted: Wed Feb 09, 2011 9:41 am
by Micah Nelson
Baron Eirik wrote:Some kingdoms may not have adopted this standard, please also check with your Kingdom rules.
Detestible ninnies hiding behind their clown noses... LIVE IN THE NOW!!!