WTB - Deep / large shield bosses

Diglach Mac Cein · Post by **Diglach Mac Cein** » Tue Jun 23, 2009 8:32 am

Looking to see if anyone makes "deep" shield bosses. With the smaller ones I've seen, my hand hits the inside of it when I get the shield handle set.

Maybe 6" across (at the inside opening, where your hand fits) by about 4 - 6" deep?

Would prefer stainless or aluminium.

No timetable to purchase, just fishing for info at the moment.

Thanks!
.

InsaneIrish · Post by **InsaneIrish** » Tue Jun 23, 2009 8:48 am

The large windrose bosses are plenty deep. I have one on my shield and I could easily put a full gauntlet in there and have room. I actually think it is too big for me.

Diglach Mac Cein · Post by **Diglach Mac Cein** » Tue Jun 23, 2009 9:01 am

Cool. Thanks!

Syrfinn · Post by **Syrfinn** » Tue Jun 23, 2009 5:55 pm

Dilan, I have a set of Bokalo's manatee gauntlets and they are a bit on the big side.

My Asgard plastic boss is 6" wide, and my gauntlet barely fits in it. But it is usuable if I wanted to go to single sword with a gauntlet if i wanted to.

I also have a windrose shield with one of his bosses. It is 6 1/2" wide and my gauntlet fits perfectly in it, with room to spare.

So i am thinking anything you make, will be smaller than my gauntlets, so should fit fine in one of Windroses.

Diglach Mac Cein · Post by **Diglach Mac Cein** » Tue Jun 23, 2009 9:20 pm

Manatee gauntlets... LOL!!!

.