Page 1 of 1
WTB - Deep / large shield bosses
Posted: Tue Jun 23, 2009 8:32 am
by Diglach Mac Cein
Looking to see if anyone makes "deep" shield bosses. With the smaller ones I've seen, my hand hits the inside of it when I get the shield handle set.
Maybe 6" across (at the inside opening, where your hand fits) by about 4 - 6" deep?
Would prefer stainless or aluminium.
No timetable to purchase, just fishing for info at the moment.
Thanks!
.
Posted: Tue Jun 23, 2009 8:48 am
by InsaneIrish
The large windrose bosses are plenty deep. I have one on my shield and I could easily put a full gauntlet in there and have room. I actually think it is too big for me.
Posted: Tue Jun 23, 2009 9:01 am
by Diglach Mac Cein
Cool. Thanks!
Posted: Tue Jun 23, 2009 5:55 pm
by Syrfinn
Dilan, I have a set of Bokalo's manatee gauntlets and they are a bit on the big side.
My Asgard plastic boss is 6" wide, and my gauntlet barely fits in it. But it is usuable if I wanted to go to single sword with a gauntlet if i wanted to.
I also have a windrose shield with one of his bosses. It is 6 1/2" wide and my gauntlet fits perfectly in it, with room to spare.
So i am thinking anything you make, will be smaller than my gauntlets, so should fit fine in one of Windroses.
Posted: Tue Jun 23, 2009 9:20 pm
by Diglach Mac Cein
Manatee gauntlets... LOL!!!
.