Is there a need for 3/4" tool shanks?
Posted: Sat Oct 31, 2009 1:21 am
I must travel to the metal supplier next month... and was wondering if anyone needs 3/4" square tool shanks to fit the small anvil hardy holes.
All I need for myself is a short piece, as my anvils have a 3/4" hardy hole.
I was going to build myself an intermediate tool kit for my anvil.
The Newbie Tool Kits were based on 1" pipe.
My last tools have been 1" solid square shanks.
If there is a need, I will get a longer length of 3/4" solid square.
If not... I'll just be getting a 3 foot length for myself.
Thank you for your support.
Hal
All I need for myself is a short piece, as my anvils have a 3/4" hardy hole.
I was going to build myself an intermediate tool kit for my anvil.
The Newbie Tool Kits were based on 1" pipe.
My last tools have been 1" solid square shanks.
If there is a need, I will get a longer length of 3/4" solid square.
If not... I'll just be getting a 3 foot length for myself.
Thank you for your support.
Hal