The Armour Archive

Hi,

I blew out my water pump on the van yesterday coming back from an event in El Centro, luckily I was only a mile away from home. But I need to get this fixed ASAP, and I don't want to raid my shipping escrow to do so.

This first helm is a Pembridge great helm made to AJA specs, was a little too big for the client. I am asking $225 OBO, plus applicable shipping. The sizing is as follows:

Front to back inside: 10.25"
Side to side inside: 8.5"
Circumfeence at eyeline outside: 32"
Front crease bottom of eyes to chin: 7.5"

The front to back measurement is narrower then the side to side?
If that's a misprint, can we get any other pictures at other angles?
Also, what is the gauge(s) and the material (mild/stainless)?

-Cian (Who needs another helm, like he needs another hole in his head, but I've been looking for a nice looking Pembridge for a while to put on display at an upcoming demo).

Hi,

The measurements were swapped, thank you and I have added a side shot. Also, the helm is SCA legal, thought the eyeslot is only 5/8" to meet the AJA reqirements. The helm is all 14GA mild except the top cap is 13GA. But it is all mild steel.

Reduced to $200, tomorrow morning it goes on ebay.

ARMOURER ERIC wrote:I blew out my water pump on the van

Hey!

You can't use that!

That's my excuse!