Page 1 of 1
One-piece raised sallet
Posted: Wed May 25, 2011 1:51 am
by Andrej Evtuh
Did this helmet for myself, but I Unlike a form: overhead part is rounded not enough. A few months I wanted remake this helmet, but it is simpler to do new.
helmet made in 2mm (about 14 gauge) mild steel.
On a head circumference 59-60cm about 23,5''
Price 270$ including delivery.
If you have questions: PM to me, or e-mail:
andrej_evtuh@mail.ru
Re: One-piece raised sallet
Posted: Tue Jun 21, 2011 2:47 am
by Andrej Evtuh
Re: One-piece raised sallet
Posted: Tue Jun 21, 2011 9:33 am
by Bo Harris
Why do you keep labeling all your helmets as one-piece? I count at least 5 on this one. Your kettle helm is in 3 pieces. I'm not trying to put down your work, it is very nice, but obviously welded and/or riveted together. Any reason you add the word one-piece? Thanks.
Re: One-piece raised sallet
Posted: Wed Jun 22, 2011 12:56 am
by Andrej Evtuh
The top of this helmet is made from one piece. Without welding. Other 2 parts on riveting. It is the historically approved technology.
Re: One-piece raised sallet
Posted: Wed Jun 22, 2011 8:00 am
by Bo Harris
Thank you very much for clarifying. I couldn't tell the top was raised from the photographs. I assume your other one-piece helms are similar; with a raised skull and then brim or other parts attached. Again, very nice work. Hope you get them sold.
