The Armour Archive

I just finished a big update on the WireWorks and I wanted to share a new deal I have going.

I have been wanting to make some maille from Titanium for a while but the cost is pretty prohibitive. So here is the deal.

Anyone wanting something made from this material, I will do the labor for free. You pay the per pound price for the rings and I will furnish the labor without charge.

This is for anything, shirts, coifs, camails etc.

You can check out the rest of the new stuff at the site.

Take Care

------------------
Épreuves plus quo noús pouvons décrire

Lord Charles DeCordené
Fyrd, Mallet, Torse (Calontir)
Squire of the body, Sir Donatto El Lobo

DeCordené WireWorks and Chainmaille Discussion Board

dccharles@hotmail.com

Sent ya an email.

Cedric

I was thinking about buddy, but I dont have anymore money to spend

about how much would it cost in rings for an aventail in 1/4"????

NOT the dang wedged type either... Expanding rings only..

Been fielding a lot of these questions, keep in mind I need several measurements to be able to make a real accurate quote but here are some estimates.

16G 1/4" I.D. rings

coif = 4-6 pounds
camail = 4-5 lbs
Avg shirt = 20 lbs

The rings run $80.00 per pound.

Take Care

------------------
Épreuves plus quo noús pouvons décrire

Lord Charles DeCordené
Fyrd, Mallet, Torse (Calontir)
Squire of the body, Sir Donatto El Lobo

DeCordené WireWorks and Chainmaille Discussion Board

dccharles@hotmail.com