The Armour Archive

This is a re-post of my last axe. The deal fell through (Life happens!), so I'm offering it again



The head is made from glued and sewn leather with a foam striking edge and covered in plastidip, then sewn to the shaved and stained rattan haft. It's 62 1/2" long without a buttspike (which I can add for you at no extra charge). $65 plus shipping. As always I take PayPal at m_kreitzer@yahoo.com, or you can elect to have me email you a paypal invoice so you can use a credit or debit card. Thanks!

That price works out to about $75 plus shipping, btw. Shipping these ain't cheap...

Alternately, you can save $15 and have me deliver it to you at Pennsic, or Baron wars if you're going there...

As a matter of fact, if you want to order one for Pennsic delivery, feel free. $75, 50% down, balance on delivery.

$65 plus shipping is the best I can do.

That's the nicest one I've seen thus far, man. If I were into SCA, I'd be all over it. GLWS.

nice though you may want to check those edges with a marshals gauge they may be able to penetrate more than .5 inches inside a helm

Thorgrimr has been doing it a while i have never seen any thing to the contrary here on the archive.

nugg

Sold!

Shoot me a pm if anyone want one for Pennsic delivery...

Thorgrimr

The head I got from you last Pennsic was pretty much destroyed at Lilies (there were alot of 6ft weapon only days:) so I am in the market:)

One question, if I ordered one, would wanting flat sides on the haft increase the price any?

Nope. Not a bit, if we're talking "oval" type cross section as opposed to "flat as a board". Totally flat would mean that I would have to buy more expensive rattan.

Re-post. Check the top post. Thanks!

One last