Page 1 of 1
cheap basket hilt relatively
Posted: Sat Mar 26, 2005 12:27 pm
by Brennus
They aren't as cheap as the 10 dollar welded hilts but they look alott better. My hilts are 30 dollars plus shipping shipping, depends where you are.
[img]http://home.armourarchive.org/members/brennus/basket.JPG[/img]
See how they look, Murdoch, when I have a decent wooden hammer around.
Sabastian I don't know if you got my last message but the post office needs an exact address to give me an amout for postage.
Posted: Sun Mar 27, 2005 8:52 am
by Brennus
I forgot to say I have two of these baskets in stock now in Aluminum. The aluminum ones are as light as the plastic n
baldar hilts and look a times better. I can also make them in Stainless they are slightly heavier but they really polish up nicely.
Fools' War
Posted: Mon Mar 28, 2005 8:34 am
by Karl Helweg
Might you be bringing some to Fools' War? I actually have a crop of newbies sprouting right now and one might need a hilt by then.
Posted: Mon Mar 28, 2005 9:29 am
by Brennus
I can make a few to bring, any word on how many you might need? I am low on aluminum right now and have a glut of stainless so they might all be stainless.
I now only have one aluminum left in stock anybody out there need it?
Posted: Wed Mar 30, 2005 5:10 pm
by Brennus
Ok I have one Aluminum one left and working on a couple of stainless ones. I may even be changing the design slightly. Get in contact if you need one . The best thing about these is if you are wearing a metal half gaunt they look like full gauntlets.
Looking 4
Posted: Sat Apr 02, 2005 8:07 pm
by Karl Helweg
All right, this was what I was really looking for. Have any aluminum ones left to bring to Fools' War?
Posted: Sat Apr 02, 2005 8:09 pm
by Brennus
I can have ten ready by then
Do you like a larger or smaller basket?
?
Posted: Sun Apr 03, 2005 9:12 am
by Karl Helweg
I'm not sure which size that I need yet. I just need to make a Meridiean "race sword." What I really want is something that I haven't seen in years; a basket hilt that is cut and fluted to look like fingers. These look like period fingered gauntlets with you half gauntlet in them but offer much better protection. Broken fingers just aren't a pilot;'s freind.
Posted: Sun Apr 03, 2005 9:59 am
by Brennus
It would be alomost impossible to do that in aluminum its just too brittle for me.
Posted: Tue Apr 05, 2005 12:09 pm
by ctopher069
i might be intrested inm a couple in aluminum in a couple of weeks. All i used is a welided basket and have never really cared for it. I want something that is a lil lighter. how much would one / both cost with shipping to Granbury TX 76048
thanks
Posted: Tue Apr 05, 2005 12:55 pm
by Brennus
one with shipping $35 two with shipping $67