WTB - tourney pavise

Lucian Ro · Post by **Lucian Ro** » Thu Oct 29, 2009 6:58 am

Anyone making them, preferably out of aluminum? It would be of the smaller variety, using it for tourney combat.

InsaneIrish · Post by **InsaneIrish** » Thu Oct 29, 2009 8:00 am

Windrose is the only armoury I know that sells a pavise blank.

Lucian Ro · Post by **Lucian Ro** » Thu Oct 29, 2009 8:04 am

InsaneIrish wrote:Windrose is the only armoury I know that sells a pavise blank.

Thanks, Irish. Looking for a larger one, though. Site says it's 20" x 28".

Stahlgrim · Post by **Stahlgrim** » Thu Oct 29, 2009 8:16 am

If you can get over to Haines city we could make one at my shop.or at least cut the blank out I would suggest going to a sheet metal shop to put the 4 bends in it for the channel
in service Stahlgrim

losthelm · Post by **losthelm** » Thu Oct 29, 2009 10:01 am

windrose or icefalcon might custom fab the pasive for you.
Shipping would probibly be expencive.

Sean Powell · Post by **Sean Powell** » Thu Oct 29, 2009 10:43 am

Windrose may not cary them but they can do them for you. It requires a break rather then just a roller. Most armorers don't have need for a brake press regularly so they would need to outsource. If Windrose can't handle a custom pavise for you then just buy a slab of aluminum, mark it with a sharpie and bring it to a sheet-metal fabricator near you to bend up.

Sean

Tomburr · Post by **Tomburr** » Thu Oct 29, 2009 11:41 am

I'm also looking for a very similar pavise.

I wonder if Windrose couldn't make a larger version of theirs, since they offer all their other shield blanks at a wide range of sizes.

Micah Nelson · Post by **Micah Nelson** » Thu Oct 29, 2009 9:48 pm

Tomburr wrote:I'm also looking for a very similar pavise.

I wonder if Windrose couldn't make a larger version of theirs, since they offer all their other shield blanks at a wide range of sizes.

Ditto.