WTB - Viking hilt and pommel

Eudo · Post by **Eudo** » Sat Oct 02, 2010 8:40 pm

Wanting to buy a viking hilt and pommel for SCA rattan. Attaching pics to show what I am looking for. I have seen the ones at Windrose Armory.

Eudo

Heath B fraychef · Post by **Heath B fraychef** » Sat Oct 02, 2010 10:01 pm

good luck.
if you find any pass the word along.

Sieghart von Ingolstadt · Sun Oct 03, 2010 12:09 am

http://www.badgersden.com/Store/index.p ... ts_id=1050

Niall Mor · Post by **Niall Mor** » Sun Oct 03, 2010 3:23 am

A friend of mine bought the aluminum ones from Windrose, then engraved round holes into it to look like one of the extant hilts.

Vebrand · Post by **Vebrand** » Sun Oct 03, 2010 8:44 am

I think Raymond's Quiet press used to do some. I would check out his site.

Vebrand

chris19d · Post by **chris19d** » Sun Oct 03, 2010 10:36 am

he does but they are for real swords.

Swete · Post by **Swete** » Sun Oct 03, 2010 11:48 am

By my hand does some incredible one piece hilt-and-guard styles. You just kinda slide your rattan into a slot and secure...sadly it seems you have to go to an event to catch him. I still scold myself for not picking up one when I had the chance.

Niall Mor · Post by **Niall Mor** » Sun Oct 03, 2010 1:00 pm

IIRC, Raymond used to make rubber hilts pre-molded onto a stick of rattan. I'm not sure if he still does this as I can't find it on his site.