One-piece raised sallet

Andrej Evtuh · Post by **Andrej Evtuh** » Wed May 25, 2011 1:51 am

Did this helmet for myself, but I Unlike a form: overhead part is rounded not enough. A few months I wanted remake this helmet, but it is simpler to do new.

helmet made in 2mm (about 14 gauge) mild steel.
On a head circumference 59-60cm about 23,5''

Price 270$ including delivery.

If you have questions: PM to me, or e-mail: andrej_evtuh@mail.ru

Andrej Evtuh · Post by **Andrej Evtuh** » Tue Jun 21, 2011 2:47 am

Bo Harris · Post by **Bo Harris** » Tue Jun 21, 2011 9:33 am

Why do you keep labeling all your helmets as one-piece? I count at least 5 on this one. Your kettle helm is in 3 pieces. I'm not trying to put down your work, it is very nice, but obviously welded and/or riveted together. Any reason you add the word one-piece? Thanks.

Andrej Evtuh · Post by **Andrej Evtuh** » Wed Jun 22, 2011 12:56 am

The top of this helmet is made from one piece. Without welding. Other 2 parts on riveting. It is the historically approved technology.

Bo Harris · Post by **Bo Harris** » Wed Jun 22, 2011 8:00 am

Thank you very much for clarifying. I couldn't tell the top was raised from the photographs. I assume your other one-piece helms are similar; with a raised skull and then brim or other parts attached. Again, very nice work. Hope you get them sold.

One-piece raised sallet

One-piece raised sallet

Re: One-piece raised sallet

Re: One-piece raised sallet

Re: One-piece raised sallet

Re: One-piece raised sallet