Just thought some of you might get a kick out of this Corinthian. Currently I hate it! The cheeks are made of two layers of 12 guage 304 Stainless, the owner was worried about denting from pikes. It definnetly makes it difficult to attach the stainless pierce work. I have blown through about 20 1/16th drill bitts so far. Its a custom piece and as such it is allready sold. Just put the pictures on to get some more interest in my products really, yea... shameless...
Just the front view (well as long as I have gotten the code right).
[img]http://stu.aii.edu/~scf381/Corinthian%20Face.jpg[/img]
Another possible front view if the code works.
[img]http://stu.aii.edu/~scf381/Corinthian%20Front.jpg[/img]
Damn I hope I have this right! This is a pain typing these addresses in.
[img]http://stu.aii.edu/~scf381/Corinthian%20Front2.jpg[/img]
This is my stunt brain assistant posing in the helm. If you the client see these dont worry, the helm has been cleaned.
[img]http://stu.aii.edu/~scf381/Corinthian%20Greek%20Pose.jpg[/img]
A view of the Left Cheek!
[img]http://stu.aii.edu/~scf381/Corinthian%20Left%20Quarter.jpg[/img]
A nice heroic view of the Right Side.
[img]http://stu.aii.edu/~scf381/Corinthian%20Profile%20Right.jpg[/img]
and finally... a view of the right cheek!
[img]http://stu.aii.edu/~scf381/Corinthian%20Right%20Quarter.jpg[/img]
Damn....I hope this works!
[This message has been edited by SterlingtheSilver (edited 05-28-2003).]
Corinthian I am working on.
-
SterlingtheSilver
- Archive Member
- Posts: 80
- Joined: Mon Jan 29, 2001 2:01 am
- Location: Portland,Or. USA
-
William Frisbee
- Archive Member
- Posts: 2465
- Joined: Thu Jul 18, 2002 1:01 am
- Location: Live Free or Die
