WTB: Basinet

BliczeSturmer · Post by **BliczeSturmer** » Sat May 13, 2006 8:02 pm

I am a newb to SCA heavy fighting and I need a helm. I am looking for the top half of a basinet (rounded point, near vertical drop in back). I will eventually add a top-hinged bargrill, which if the seller could also provide would be even better, and a riveted maille aventail. Preferrably 14 gauge steel (NOT STAINLESS) for a very small head. Please let me know if this is possible since the only basinets being sold are complete basinets (that I found anyways). Thanx.

Blicze

P.S. Ron Simmons was recommended, so please respond if you are him.

Klaus the Red · Post by **Klaus the Red** » Mon May 15, 2006 3:05 pm

Ron Simmons' Rough-From-the-Hammer business has been taken over by Dave "Cet" Rylak, a frequent poster here. You could PM him or add a page notice to him in the title of this thread.

ARMOURER ERIC · Post by **ARMOURER ERIC** » Mon May 15, 2006 8:08 pm

Sent you a PM yesterday, did you get it.

Eric